Aces High Bulletin Board
Help and Support Forums => Technical Support => Topic started by: Dmitry on April 07, 2001, 06:08:00 PM
-
<S> all...
Have this weird problem... After reinstalling Windows this happened:
1. The resolution cannot be changed - It has options like 640x480, 1024x768 and so... However If I choose 1024x768 or other it will blink and stay same 640x480.
2. After restarting it still at 640x480.
3. The only thing that works is deleting TNT II from System and then it will work on the resolution previosly choosen.
4. After restarting computer it finds "New Device" - TNT and problem is back..
I am running PIII -500, Win98SE, AGP TNT 2 with 32 Mb...
Any ideas?
Thank you in advance...
------------------
Best regards
Dmitry aka vfGhosty
-
What is your monitor detected as?
If your monitor is not detected or setup properly, Windows won't push higher resolutions for fear of popping your monitor.
Make sure your monitor is setup properly.
Next thing is to remove the drivers for the TnTII again, and this time install a different version. dangerousdog.com has the latest 11.01's if you want.
------------------
Sean "Lephturn" Conrad - Aces High Chief Trainer
A proud member of the mighty Flying Pigs
http://www.flyingpigs.com
Check out Lephturn's Aerodrome (http://users.andara.com/~sconrad/) for AH articles and training info!
-
Thank you very much...
------------------
Best regards
Dmitry aka vfGhosty