Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: Krusty on August 03, 2007, 11:22:37 AM

Title: Hardware controller question...
Post by: Krusty on August 03, 2007, 11:22:37 AM

Say you have a throttle like that CH quad throttle, has 6 levers.

Say you map 4 of them to throttles 1, 2, 3, 4. Can you "just" map the last to to RPM 1, 2?

Will that mean RPM 1,2 are mapped only to engines 1,2 (because you have all 4 engines mapped), or will it do it as RPM left/right, as if you were in "twin" throttle configuration?

If you just had 2 throttles and 2 RPMs I can see how it works, but what if you had 4 throttles and 2 RPMs? Does that throw a wrench in the works?

Title: Hardware controller question...
Post by: BennyBeaver on August 03, 2007, 11:57:49 AM

hmm maybe what you should do is program it then try it out in offline mode.

Title: Hardware controller question...
Post by: Krusty on August 03, 2007, 11:59:51 AM

Don't have one. Thinking about it though :)

Title: Hardware controller question...
Post by: SIK1 on August 03, 2007, 12:03:05 PM

Krusty I'm not positive about this but I believe that the rpm would be for engine 1, 2, and not left bank, right bank.