Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: df54 on August 29, 2007, 04:47:36 PM

Title: ch combat stick-568
Post by: df54 on August 29, 2007, 04:47:36 PM

I recently purchased a 568 combat stick and despise the trim wheels to the right and below the stick itgself.  Is there any way to disable the wheels without taking anything apart.

Title: ch combat stick-568
Post by: Auger on August 29, 2007, 05:03:16 PM

Electrical tape would cover them and not be too obvious.  It may tend to curl on you though.  If you can find black duct tape it might work better.  For a more permanent solution, some epoxy or super glue would also work.

Title: Re: ch combat stick-568
Post by: Ack-Ack on August 29, 2007, 06:05:18 PM

Quote

Originally posted by df54
I recently purchased a 568 combat stick and despise the trim wheels to the right and below the stick itgself.  Is there any way to disable the wheels without taking anything apart.

Leave those trim wheels alone.  They are there to trim the potentiometers in your stick.  I highly recommend that you do not disable them at all as you may need to fine tune your stick's calibration and those trim wheels are how you fine tune.  

ack-ack

Title: ch combat stick-568
Post by: Bruv119 on August 31, 2007, 08:42:02 AM

I have this stick also.

if you do move them make sure you return them back to the centre notches.

They are for what AKAK   describes.