Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Anodizer on June 30, 2008, 09:17:56 AM

Title: X-45 drivers ok?
Post by: Anodizer on June 30, 2008, 09:17:56 AM

Greetings Earthlings... :salute
I've had this x-45 for a bit now and am fairly satisfied with it..  However, I'm not able to figure out how to use the 2 aux switches on the throttle..  When I try to set it up in AH's control settings, it just switches the switch itself to another button, but not another button on the stick/throttle..  I'm figuring the aux switches are "shift" keys, right?  So, do I need to install the Saitek drivers to make this work?  Forgive my ignorance since I've never used this kind of set up until just a few months ago..  Many thanks..

Title: Re: X-45 drivers ok?
Post by: Ghosth on June 30, 2008, 10:34:03 AM

Since they are "shift" or "mode" keys, try setting them to change modes. I think you'll find if assigned to that they should work.

BTW you can do all kinds of neat things once you start switching modes.