Aces High Bulletin Board
General Forums => Aces High General Discussion => Topic started by: AKNiteflyr on August 23, 2000, 11:03:00 AM
-
Howdy: I have a small problem with joystick imput. I have been on for sometime and ya would think by now I would have it worked out. Wrong right now I have all my Slider bars max out (meaning they are all the way to the top), this I understand is suppose to make the control linear and as long as i fly straight and level and do nothing abruptly all is fine with the world. But if i have to manevoer to get out of the way of being shot or trying to shoot some one else all i get is a constant stall horn even at cruise at 300 ias into a hard anything, turn climb push over into decent and its stall warning time followed by loss of E then departur from control flight.
I currently use a Microsoft Precison pro which i like and for the most part works real well, just wish I could do more then just straight and level for a change with out alot of buzzing in my ear.
ps: I also have the deadzone set to almost nil and dampen about a quarter on those sliders.
So any suggestions..????
Thanks in advance (http://bbs.hitechcreations.com/smf/Smileys/default/smile.gif)
-
Adjust the joystick sensitivity sliders to start low and increase from left to right. This will give you finer control when the stick is near center. You may need different profiles for each axis.
You may have a bit too much dampening, try reducing it a bit.
Dial in enough deadband to eliminate spiking.
Also, keep your plane in trim as much as possible. Use the "auto pilot" modes when you can, and use manual controls when maneuvering. As your speed changes, adjust trim to keep the stick near the center. With the slider settings described above, this will give you fine control in all situations.
popeye
-
Thanks Popeye will give it a shot.
(http://bbs.hitechcreations.com/smf/Smileys/default/smile.gif)