Aces High Bulletin Board
Help and Support Forums => Aces High Bug Reports => Topic started by: Widewing on September 17, 2008, 10:18:32 PM
-
F6F-5:
Rocket tabs always shown, even when no rockets are selected.
Impossible rear view... Needs more lateral head travel, head doesn't get anywhere near canopy glass.
IL-2: I only flew it with 37mm guns... However, they shoot very high, well above sight center at 400 yards. Exacerbated by fixed gun sight. See below.
(http://home.att.net/~historyworld/IL-2-37mm.jpg)
My regards,
Widewing
-
not being silly, cos i know your a pro and you know what your talking about but.... what did you have the convergence set up as?
maybe try a few settings and post results? (i dont fly it).
ie see if it repeats it with guns set at 200 and the target set at 200, 300/300, 400/400 etc
-
ya gotta just move your head around and F10 it in the new position when you find it, since its a fixed sight..
-
That's not the proper way to fix it. The guns should hit the gunsight in default position.
I did notice, however, that with the 37mm I seemed to land rounds on the offline tank drones easily. I didn't test them enough to notice them *that* high off the mark, but when shooting down they seemed spot-on.
Go figure :confused:
-
if you look at like the weird little secondary sights on the p40, p47, its the same thing.. you have to move your head to use them
i have a dot drawn on my LCD monitor where the bullets go.. I just had to move head around a little in the IL2 to get the dot right in the center of the sight.. i could shoot without doing that, I could just put the dot on the target.
-
Hit the home key to reset your head position to the default location. If your saved head position is other than the default, the sight will be off.
-
Works fine for me.
(http://i156.photobucket.com/albums/t5/AK_Comrade/il2.jpg)