Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: United625 on January 01, 2009, 04:15:48 PM

Title: Sensitive Z Axis
Post by: United625 on January 01, 2009, 04:15:48 PM

My joystick is old and its Z axis seems to have a mind of its own. It is Wingman Extreme Digital 3D and I have tried to pull it apart but have failed to.

Is there anyway to allow me to ignore the Z axis, it prevents me from flying and gives me the "You are moving your controls too rapidly" error.

Title: Re: Sensitive Z Axis
Post by: The Fugitive on January 01, 2009, 10:27:04 PM

I believe you can remove it in the "map controllers" section of the notebook. I think if you highlight the Z axis, then assign it to "none" it will remove it.

Title: Re: Sensitive Z Axis
Post by: Skuzzy on January 02, 2009, 06:13:53 AM

Adjust the "deadband" for that axis to a higher amount and the game will ignore the spiking from it.

In the "Map Controllers" panel. select the "Z-Axis", then check the "Advanced" box.  You will see the "deadband" slider in the panel that swings open from the clipboard.  Just move it up until the desired effect is reached.