Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: Flifast on May 18, 2009, 10:39:24 PM

Title: X52 axes
Post by: Flifast on May 18, 2009, 10:39:24 PM

How can I get the x y axes centered.  I do the calibration...stays where it is at everytime and the X52 profile control panel show it off to the right also but I can't move it.  It's a new X52 after the last one wore out.  Fli

(http://i179.photobucket.com/albums/w312/fliifast/x52axes.jpg)

Title: Re: X52 axes
Post by: bustr on May 19, 2009, 03:15:15 AM

Try reinstalling the Saitek drivers. If this is an X52 Pro and you simply plugged it in out of the box letting the old install pick it up, reinstall drivers.

Title: Re: X52 axes
Post by: Flifast on May 19, 2009, 08:50:10 AM

I turned on the computer checked this site and went to the X52 control panel and everything was centered...these computer people sure know how the rest of us work.  It's the same for the Airbus 320, shut it down and reboot and i'll clear all your problems!  TY Fli