Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: Hopper on June 11, 2009, 11:38:59 PM

Title: Small Problem in the Dora
Post by: Hopper on June 11, 2009, 11:38:59 PM

I've noticed when I lower the RPM's at certain times they will not go below 2500.  I think this is just a visual glitches because I can tell by the EA6B that it goes lower than that.  I will look down some time later and it will have dropped below 2500 to its correct position.  I have only seen this happen in the 190-D.  Not a big problem, but maybe someone could pull out the iron and take out some wrinkles sometime.

Edit: Should have went to Bug Reports, my bad.

Title: Re: Small Problem in the Dora
Post by: CountD90 on June 12, 2009, 02:44:28 AM

at high speeds the rpm wont go below a certain point IIRC

Title: Re: Small Problem in the Dora
Post by: Hopper on June 12, 2009, 05:55:48 PM

I'll test it again your probably right.