Aces High Bulletin Board
General Forums => Films and Screenshots => Topic started by: warphoenix on January 09, 2010, 11:20:56 PM
-
here id the link: http://www.speedyshare.com/files/20244362/joystick_problem.ahf
every time it banks left my joystick is in the nutural posistion it happens every time in every plane exept the heavy bombers, any ideas?
-
Didn't watch the film but it's probably not calibrated.
-
In your windows control panel you have a "game controllers" option. Bring it up. In there, you should see an entry for your joystick.
Click your joystick, and "properties" -- and look at the screen that comes up.
It should have a box with a little "+" sign in it that moves up/down and left/right as you move your stick. With your stick at rest you should see it near the center. As you push forward it should move up, and push left it'll go left.
Really basic setup 101 stuff. Make sure it's working okay. If it's NOT, go through the calibration setup. It will be in this same window (either on this or the next tab it has). Make sure you READ and FOLLOW each step as it comes up. When you are done go back and test the box with the "+" in it again.
Then once that's all done, and works in windows fine, go into aces high and in your clipboard settings calibrate your stick there. Make sure you calibrate ALL axis, including rudder, throttle, and X/Y (up/down/left/right).
-
Didn't watch the film but it's probably not calibrated.
I calibrated it twiceIn your windows control panel you have a "game controllers" option. Bring it up. In there, you should see an entry for your joystick.
Click your joystick, and "properties" -- and look at the screen that comes up.
It should have a box with a little "+" sign in it that moves up/down and left/right as you move your stick. With your stick at rest you should see it near the center. As you push forward it should move up, and push left it'll go left.
Really basic setup 101 stuff. Make sure it's working okay. If it's NOT, go through the calibration setup. It will be in this same window (either on this or the next tab it has). Make sure you READ and FOLLOW each step as it comes up. When you are done go back and test the box with the "+" in it again.
Then once that's all done, and works in windows fine, go into aces high and in your clipboard settings calibrate your stick there. Make sure you calibrate ALL axis, including rudder, throttle, and X/Y (up/down/left/right).
I'll try that thx
-
you might also be feeling normal torque from the propeller... you'll need to adjust your trim to compensate for this.