Aces High Bulletin Board
Help and Support Forums => Aces High Bug Reports => Topic started by: TequilaChaser on May 13, 2010, 09:57:37 AM
-
I have tested this in both Windows XP pro 32 bit & Windows 7 Ultimate 64 bit
preferences are changed upon updating the game..... for both OS's
* auto film sorties is checked and works correctly, although if you uncheck it and close out the preferences back to main clipboard.it reverts back to being on.........it does film properly though and ends film when exiting/finishing sortie
* Auto take-Off is disabled..if you enable it and go to launch...it appears as being on briefly but as engine revs up it immediately shuts off......go back in and checked and it was "unchecked" again
* auto combat trim - I checked it to be on/used...launched and it stayed on.but when I go back to preferences/flight it shows as unchecked , again.rinse repeat.same thing.is on only for that flight.upon exiting flight.it is unchecked
* can not click / check Tracers OFF....... will not hold its setting at all........
--------------------------------------------------------------------------------------------------------------------------------------------
as for Screen Resolution ( what shows in top Left corner beside Ver. 2.19 patch 0 )
before ver. 2.19 mine was as follows:
WinXP using DELL 19" UltraSharp (non-wide screen) set at & showing 1280 x 1024 correctly
after 2.19 update shows: 1288 x 1032
before ver. 2.19 mine was as follows:
Windows 7 64 bit using DELL 19" UltraSharp (non-wide screen) set at & showing 1280 x 1024 correctly
after 2.19 update shows: 1296 x 1040
regardless if I use autoset for field of view.or use custom set and set it to 90 degree field of view....it does not help with my natively set 1280 x1024 screen resolution....
very strange.....
the preferences/flight seems to be happening in most all arenas, I checked in the main arenas and also in the Training arena.....
could this Screen Res indifference be causing some of the mouse freeze or or stutter problems? perhaps
hope this helps....... will email DXDIAG if needed
-
I just noticed my screen res was slightly different too. I run in 1680x1050 and AH said it was running in 1692x1026 (I think 1026 is right, it could have been something different, but it was definitely not 1050).