Aces High Bulletin Board

Help and Support Forums => Aces High Bug Reports => Topic started by: katanaso on June 03, 2010, 04:22:12 PM

Title: GV Bug?
Post by: katanaso on June 03, 2010, 04:22:12 PM

I took out a Wirblewind last night, got it up to speed, and upon switching into either gun position it would automatically go into a continuous left hand turn.  When I switched back into the driver's position, it would go straight again.

Is this a bug, or working as intended? :)


mir

Title: Re: GV Bug?
Post by: Lusche on June 03, 2010, 04:32:19 PM

Sounds like you are somehow applying left rudder. Involuntary stick input?

Title: Re: GV Bug?
Post by: katanaso on June 03, 2010, 04:42:19 PM

I took my feet off of the pedals and let go of the stick, and I didn't see any movement in the calibration screen.

Is it possible to turn these with pedals while in a gunner's position?

But from your reply, it's easy to see it's something on my end.  I'll go in and test a few times.  Thank you. :)


mir

Title: Re: GV Bug?
Post by: Lusche on June 03, 2010, 04:44:42 PM

Quote from: katanaso on June 03, 2010, 04:42:19 PM

Is it possible to turn these with pedals while in a gunner's position?

Yes. In any position but the drivers, you steer the tank using the rudder axis.

Title: Re: GV Bug?
Post by: Clone155 on June 03, 2010, 08:46:57 PM

I seemed to have the same problem a few days ago. I re-calibrated and everything worked fine again.

Title: Re: GV Bug?
Post by: katanaso on June 03, 2010, 10:21:06 PM

So I figured out what it was -- the little stick on my CH Throttle.  That turns the GV left and right.  It never did before.  I had to set a huge deadband on it and all is well.

Thanks. :)  GVing was fun tonight since I could turn while firing the guns.... :)