Aces High Bulletin Board

Help and Support Forums => Aces High Bug Reports => Topic started by: 1701E on June 18, 2010, 11:20:30 AM

Title: Transparency issues
Post by: 1701E on June 18, 2010, 11:20:30 AM

Just a few small ones:

F2.B:
>This applies to every wing on the F2.B and you can see through both the top and bottom from that angle.  There were no holes in the wing surface so the cloth acts like 1-way glass.

(http://i682.photobucket.com/albums/vv181/Xcelsior1701/Aces%20High%201/ahss67.jpg)


D3A:

(http://i682.photobucket.com/albums/vv181/Xcelsior1701/Aces%20High%201/ahss71.jpg)


B-26:
> Little harder to spot but the Noseart (on the tail) can be partly seen from the opposite side it's on.

(http://i682.photobucket.com/albums/vv181/Xcelsior1701/Aces%20High%201/ahss72.jpg)

Title: Re: Transparency issues
Post by: curry1 on June 19, 2010, 04:30:53 PM

good eyes

Title: Re: Transparency issues
Post by: 321BAR on June 20, 2010, 07:12:54 AM

man, i thought i was good at spotting things. good job

Title: Re: Transparency issues
Post by: caldera on June 20, 2010, 10:00:20 AM

Had the same issue with different planes. 

(http://i343.photobucket.com/albums/o460/caldera_08/AH2%20screenshots/ahss6.jpg)


Also had this weirdness happen with the CV.  Ack firing from stealth carrier.  Was in the last two days, but can't remember map.

(http://i343.photobucket.com/albums/o460/caldera_08/AH2%20screenshots/ahss3-1.jpg)

(http://i343.photobucket.com/albums/o460/caldera_08/AH2%20screenshots/ahss2-1.jpg)

Title: Re: Transparency issues
Post by: Spikes on June 20, 2010, 06:13:18 PM

Also the 500kg bombs have a slight transparency to them. It is barely spot able but you can see it when you F3/F8 and move around the 234...you can slightly see through the bomb to the fuselage.

Title: Re: Transparency issues
Post by: Superfly on June 21, 2010, 09:22:21 AM

That cv shot is because you are in F3 mode while you are in the hangar, I believe.