Aces High Bulletin Board
General Forums => Hardware and Software => Topic started by: [Sg]ShotGun on September 06, 2000, 06:42:00 PM
-
well like i said i got a suncom USB stick at the WB con in june but got no USB pedals or throt...but i still have my CH pro throt and non-pro pedals. i tried to see if i cood get them all to work but cood not get the pedals or throt to show up in windows98 calibration program untill i contected the CH stick to them as if i was using it.
the only prob with this was that the buttons on the throt worked, but i cood not get the the eng RPM to move with the throt or the rudder to move with the pedals!!
how do i make gameport CH rudders/throt to work with a USB stick??
BTW..the usb stick works no prob...
-
I use a usb stick with gameport pedals and throttle . The first thing you have to do is assign the axis to the right controller. X and Y axis assign to the stick; Z axis to the throttle I believe, and the remainding fourth axis to the pedals . Incedentally, how is the suncom usb ? Does it spike or drift at all ?
-
ok...in where do u assign the axsis'
the suncom works great..for the short time i used it..the controls moved much smoother than when they were under the control of the gameport stick...
-
setup, joystick, select joystick