Aces High Bulletin Board
General Forums => Hardware and Software => Topic started by: Pongo on December 03, 1999, 10:20:00 AM
-
Well after an online poll of rooks to find a good way to convince the wife I needed a sb live card, I settled on better to beg forgiveness than ask permission.
So I swapped out my sb16 and plugged in sb live. Poof neat new system sounds.
But I can’t get the joystick port to work.
In system it says I have a working joystick port but my logitech Wingman Interceptor can’t see it.
Any suggestions?
I have a asus p2b board and the only other card I have is a tnt card.
Any help would be appreciated.
-
I had problems with my TnT card as well Pongo- related to my Joystick port. Try reducing resolution and see if it works?
Mine was porked until I dropped to 800x600 desktop and game res. Then it worked!
------------------
If your in range, so is the enemy.
-
Pongo I have sb live value and tnt2 it all works fine. make sure you have the driver loaded. for game port.
------------------
Tommy (INDIAN) Toon
Cherokee Indian
My Homepage
Where you can find the Key Commands in files for Word6 Wordpad and text mode.
indians Homepage (http://www.geocities.com/~tltoon)
Aces High Word6 and Wordpad Doc's available on my web site.
-
Have you looked for any possible hardware conflicts?
Checked for that if that SB16s joystick port driver still exists in system hardware profile?
-
Thanks guys.
I removed all of the extra programs that SB installed and it worked!
I have used RW succesfully. (http://bbs.hitechcreations.com/smf/Smileys/default/smile.gif)
While I had the case open I decided to give overclocking a try. I sped my 366 celeron up to 458 and it runs no problem. Added 10 FPS in AH..
Thanks again guys.