Aces High Bulletin Board

General Forums => Staged Missions => Topic started by: JC67 on October 08, 2010, 06:03:54 PM

Title: help
Post by: JC67 on October 08, 2010, 06:03:54 PM

ok i know im just missing something silly, but how do ya get the ai planes to climb to alt   say on a bombing run?

Title: Re: help
Post by: CaptCarnage on October 08, 2010, 08:29:12 PM

I am betting with a warp point... In all the missions I have seen were the AI planes must get above 10K feet. Warp points are used.

Title: Re: help
Post by: JC67 on October 09, 2010, 01:44:16 PM

i cant get themoff the deck  i dont know where the input or what ya do to make them climb alt

Title: Re: help
Post by: USRanger on October 09, 2010, 10:08:28 PM

In the properties box for each segment, use must set the segment type (takeoff, cruise, attack, etc.), the speed for the segment & the Dest. Alt, which is the alt the aircraft will reach at the end of the segment.  If you have them climbing from 0 to 10,000 ft., make sure it is a long enough segment for them to do so, or break it up into multiple segments.

(http://img232.imageshack.us/img232/1497/70534442.jpg) (http://img232.imageshack.us/i/70534442.jpg/)

Also remember to always hit the Fill Segment To End and Calculate boxes/buttons in each segment after changing the speed and/or alt.  The changes to the segment won't go into effect until you do so.  Ignore the water droplet in the pic, that's just my cursor that got in the way.

Title: Re: help
Post by: JC67 on October 10, 2010, 01:57:07 PM

cool  thx Ranger :aok