Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: TDeacon on November 14, 2010, 08:36:19 PM

Title: Lead computing gunsite problem?
Post by: TDeacon on November 14, 2010, 08:36:19 PM

Somehow, I have caused my lead-computing gunsite to show 2 (two) aimpoints.  I thought it was only supposed to show one.  Any thoughts on this?

Thanks in advance,
MH

Title: Re: Lead computing gunsite problem?
Post by: fuzeman on November 14, 2010, 08:51:55 PM

It is supposed to show two as you have a primary and secondary gun.

Title: Re: Lead computing gunsite problem?
Post by: TDeacon on November 14, 2010, 10:32:58 PM

On the P51, it only shows one.  I suppose that is because both primary and secondary have the same ballistics?

Title: Re: Lead computing gunsite problem?
Post by: Ghastly on November 14, 2010, 10:48:09 PM

It will show two points if you have differing convergence for your guns, and I believe it shows 2 points when you have rounds with differing muzzle velocities - most noticeably when you are pulling G's especially (i.e, bb's and cannon).

If you did something to change it from what it was like before in a certain plane, check your convergence settings.

<S>

Title: Re: Lead computing gunsite problem?
Post by: FireDrgn on November 17, 2010, 08:48:20 PM

It will show two if u have different caliber guns.   Like on the yak it has mugs and mm...