Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Max on November 11, 2001, 03:48:00 PM

Title: Adding CH Pro Peds to Saitek Cyborg USB
Post by: Max on November 11, 2001, 03:48:00 PM

I'm using a Cyborg Gold USB stick and have a set of CH Pro Peds USB.

The peds are set to ID #2 in CP Gaming devices.

I used the AH stick set-up to deselect the rudder from the Cyborg twist and assigned it to Pro Peds and the Z axis.

The rudder doesn't work and everything else spikes like crazy. What am I doing wrong?

DamnedMax

Title: Adding CH Pro Peds to Saitek Cyborg USB
Post by: Sancho on November 11, 2001, 05:14:00 PM

Same setup here, USB Cyborg Gold and USB CH Pro pedals.  My pedals are ID 1 and my Cyborg #2.  No problems here.

Make sure the last slider in each axis in joystick setup goes to 100% or you may see spiking with full deflection.  If you are getting spiking still, the stick may be going bad.

Title: Adding CH Pro Peds to Saitek Cyborg USB
Post by: Max on November 11, 2001, 05:42:00 PM

Sancho -
any chance you could e-mail your phone # so I could chat this problem out?

topchef@sover.net

Thanks!
DamnedMax