Aces High Bulletin Board
General Forums => Aces High General Discussion => Topic started by: califdune on January 14, 2011, 04:27:27 PM
-
My joystick had some wire chafing problems where the wires leave the stick into the base. when this happened it yanked wires out of the plastic plug that goes into the circuit board. If you have this joystick can you please take the base off and point out what color wire goes where into the plastic plug. I appreciate any time and effort. I tried to go through saitek but no luck
Thank You
-
hope this helps...
(http://i191.photobucket.com/albums/z235/nathanyoung1980/DSC00588.jpg)
(http://i191.photobucket.com/albums/z235/nathanyoung1980/DSC00587.jpg)
-
the wires run down the shaft of the joystick into the base. those same wires then go to a plastic plug that will plug into a board in the base its a 12 pin plug
-
no this isnt the wiring plug i need to see. the wires coming down the stick shaft go to a plastic plut its a 12 pin plug thats the one i need the color order with
-
This is from the x52Pro I modified for my simpit
(http://332nd.org/dogs/baumer/BBS%20Stuff/x52ProMod/x52Pro.jpg)
Sorry the colors didn't come out better, I'll list them below.
Going top to bottom on the left side of the picture above;
1-Red
2-Pink
3-Gray
4-Blue
5-Yellow
6-Green with White Stripe
Going top to bottom on the right side of the picture above;
1-Empty
2-Black
3-White
4-Violet (or Dark Gray depending on the light)
5-Green
6-Orange
Hope that helps