Aces High Bulletin Board
General Forums => Aircraft and Vehicles => Topic started by: viperzero on February 15, 2011, 05:30:15 PM
-
does anyone know how to change the salvo settings????????
-
type in your text buffer;
.salvo x
(replace the x with salvo #)
-
type in your text buffer;
.salvo x
(replace the x with salvo #)
thanks :D ive been trying to figure that out for awhile now
-
:cheers:
-
you can also change the delay between the release of each bomb with the ".delay #.##".
-
you can also change the delay between the release of each bomb with the ".delay #.##".
haha thanks
-
:cheers:
:cheers:
-
:cheers:
:cheers:
:cheers:
-
I love this option! when I was learning to bomb**** GV's I was very frustrated. At first I missed nearly every time. I changed the Hvy Ftr settings to salvo 2 Delay .25 I would aim one bomb below the target in my sight, then when I pushed "B" I would pull back on the stick at the same time. Almost 100% Kill rate after that. When I started looking over my shoulder while pulling up I could see my bombs go off and their location relevant to the target. Films helped me get accurate as well. All these helped me to get one bomb kills. When bombing town in Lancs I come in low level over water. Use trim so I'm almost slapping the water with the props, settings at salvo 18, delay 0.1. As I arrive I pull up above 400 ft and let 'em go. I will level the entire town center & any enemy GV feeling safely hidden. Very valuable options IMO. :salute :old: