Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: awrabbit on September 05, 2011, 03:36:33 AM

Title: linux and ch products
Post by: awrabbit on September 05, 2011, 03:36:33 AM

Has anyone figured out how to get  the CH fighterstick USB to work with Aces High and Linux ? 

any ideas before i go back to winders ?


thanks in advance.

Title: Re: linux and ch products
Post by: gpwurzel on September 06, 2011, 03:49:25 PM

There is a utility that will make linux recognise your js Rabbit, for the life of me can't remember the name of it tho. Think its something like qbit maybe.

Found a work around for it also:-
after plugging in the joysticks, run "lsusb -v" - and afterwards, the joysticks start to work magically.

If your happy with installing drivers etc, also found this http://atrey.karlin.mff.cuni.cz/~vojtech/joystick/ (http://atrey.karlin.mff.cuni.cz/~vojtech/joystick/)

If I remember the full name of the other one, I'll update further.

hth,

Wurzel

Title: Re: linux and ch products
Post by: awrabbit on September 08, 2011, 01:01:18 PM

thanks ill check it out.

for now until I get it working I set up as a dual boot into windows.   

Title: Re: linux and ch products
Post by: CRYPTIC on September 17, 2011, 02:00:36 PM

I believe I saw something over at the CH Hanger when I was looking for something else. I'm not sure if they got it working or not I didn't read it.

Title: Re: linux and ch products
Post by: awrabbit on September 17, 2011, 10:01:58 PM

thanks. will check it out.