Aces High Bulletin Board
Help and Support Forums => Help and Training => Topic started by: Spork on February 16, 2012, 02:01:31 PM
-
Any way to view the entire skin before getting out on the runway and doing F3 so I can get a 360 degree view of what it actually looks like? I know you can view it in the hanger and the convergence tab but the viewing angles are really limited.
Spork
-
Hit F3 then use your num_keys to view while in the hanger. Use your zoom in and out keys to get closer or farther away. F1 when you are done.
And if you want to surprise yourself. Pick any HUB cannon bird like a 109 or yak. Go into convergence mode. Pull the green cannon line back to 150. F3 and Num_4 or 6 I think, and look at the up angle from the spinner to intersect with the hood MG line. HUB cannon were locked inline with the engine airscrew shaft. The rounds as soon as leaving the barrel started falling towards the center of the planet. The only time the rounds were arched up was if the nose of the plane was angled up by the pilot or a nose up attiude while flying level at low speeds. Planes like the P38, 110, 262 and mossi, the nose guns could be angled up.
-
The hanger in a CV also gives a better angle than the hanger at an airbase.
-
You can get a preview of it by checking out the AH skins catalog page I set up. It's mostly up to date (aside from a few new additions that I have to update)
http://www.nakatomitower.com/ahskins
-
You can get a preview of it by checking out the AH skins catalog page I set up. It's mostly up to date (aside from a few new additions that I have to update)
http://www.nakatomitower.com/ahskins
Nice Krusty! Thanks
:salute
Spork
-
offline works too