Aces High Bulletin Board

Help and Support Forums => Aces High Bug Reports => Topic started by: aztec on September 01, 2012, 09:49:15 AM

Title: Engine On/Off Issue
Post by: aztec on September 01, 2012, 09:49:15 AM

I have my Ch Fighterstick prorammed thru AH, I can start my engine with the button I have programmed for it but it does not shut engine down. I simply programmed the button to the e key.

I have a Squad Mate with the same issue, I'm curious if anyone else has had this problem. :salute

Title: Re: Engine On/Off Issue
Post by: Chalenge on September 01, 2012, 05:31:05 PM

Is it possible that you might be changing modes and that the button has a different assignment in the second mode?

Title: Re: Engine On/Off Issue
Post by: Pyro on September 04, 2012, 10:07:35 AM

Are you using CH software to map it or are you mapping it in AH?

Title: Re: Engine On/Off Issue
Post by: 10thmd on September 04, 2012, 11:15:02 AM

My issue was in the 410 when one engine had already shut down due to overheating.
My second engine recieved a rad hit and I couldn't shut it down. I always use the E key and never bind engine on/off to any of my controllers.

Title: Re: Engine On/Off Issue
Post by: aztec on September 19, 2012, 07:53:03 AM

Quote from: Pyro on September 04, 2012, 10:07:35 AM

Are you using CH software to map it or are you mapping it in AH?

AH mapping Pyro.

Title: Re: Engine On/Off Issue
Post by: branch37 on September 19, 2012, 11:35:44 AM

Map the button to start/stop engine.  IIRC there are a few commands that can be mistaken for what you are trying to do.  I had the same problem with my X-52, I just had to find the correct command.

Title: Re: Engine On/Off Issue
Post by: fuzeman on September 19, 2012, 11:52:55 AM

fication from Clara, I have a CH Pro usb Throttle and I have my button programmed under 'Mode 1 (Planes & Default), Flight, Engine Start/Stop' , that the one you are using?