Aces High Bulletin Board

General Forums => Wishlist => Topic started by: WW1965 on April 04, 2013, 09:05:41 AM

Title: Axis Scaling ...
Post by: WW1965 on April 04, 2013, 09:05:41 AM

I've always wondered why the axis scaling only goes to 90%..

Shouldn't it go to 100% ??

that would stop the spiking of the controls in 'that last 10%'...

Just a thought..

Title: Re: Axis Scaling ...
Post by: VonMessa on April 04, 2013, 09:20:29 AM

It is a tithe to the AH Gods.

Title: Re: Axis Scaling ...
Post by: Mar on April 04, 2013, 09:23:54 AM

I'm pretty sure it means 90% and up...

Title: Re: Axis Scaling ...
Post by: WW1965 on April 04, 2013, 11:35:06 PM

Quote from: Mar on April 04, 2013, 09:23:54 AM

I'm pretty sure it means 90% and up...

Hiya Mar, no at least that's no what I'm seeing.. the last 10% of stick travel, it spikes very quickly from 90 to 100%..
thats just what I'm seeing..

Quote from: VonMessa on April 04, 2013, 09:20:29 AM

It is a tithe to the AH Gods.

LOL but there is gnashing of teeth here.. LOL

Title: Re: Axis Scaling ...
Post by: Mar on April 05, 2013, 09:16:03 AM

I just looked at it a little closer, the 90 slider controls what the elevator does according to where your stick is between 90% and 100% of its deflection. If you set that slider any lower than maximum it will spike when your stick hits 100%.

Title: Re: Axis Scaling ...
Post by: FLS on April 05, 2013, 04:44:55 PM

Quote from: WW1965 on April 04, 2013, 09:05:41 AM

I've always wondered why the axis scaling only goes to 90%..

Shouldn't it go to 100% ??

that would stop the spiking of the controls in 'that last 10%'...

Just a thought..

You're asking for less than full control deflection. You can do that already by moving your stick less.