Aces High Bulletin Board
Help and Support Forums => Aces High Bug Reports => Topic started by: morfiend on July 27, 2015, 11:02:04 AM
-
The elevator trim indicator on the C202 and 205 are reversed!
If you trim up the indicator moves down on both A/C. It appears correct when on the runway but as soon as you take off it reverses itself.
:salute
-
I don't see that on my PC Morf. Trim is normal on both.
-
I don't see that on my PC Morf. Trim is normal on both.
If you turn on combat trim and let it trim the plane it will show up reversed! I tested it last week and noticed it was fine on RW and fine if you manual trim but when you turn on CT it seems to indicate it in reverse.
I will check later again to confirm or deny..... :devil
:salute
-
I am check this now,when you drop flaps with CT on,normally the planes dial in full up elevator,the C202/205 both dial in full down elevator. When you pitch up it dials in down trim and when you push the nose down it shows up trim being applied.
All other planes behave opposite to this,not a huge deal as you can barely notice the trim indicators but none the less it seems to be a bug.
:salute
-
Have you checked it in the open alpha?
-
Have you checked it in the open alpha?
As of yet,no! RL has been kicking my butt lately,when I do get to fly I'm busy helping and trying to find my own fun so I havent bothered to install the alpha.
I had planned on installing the alpha this past weekend,but I never found the time too....... :o
:salute
PS: Bustr,you could check and see if it's correct or not and report,that would save me alot of time!!!