Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: yipi on February 09, 2016, 07:04:37 PM

Title: Warthog config for joystick axis not recognized
Post by: yipi on February 09, 2016, 07:04:37 PM

I have a Warthog Stick. It has been working fine but now it will not recognize my config for joystick axis (using s curve with reduction). It normally would show up in Aces High where the axis would be reduced as I configured in the Warthog Target program but now it will not recognize it and goes to full axis. I can program a button in the Target software and it works in Aces High so I know the software is working. Any Ideas

Title: Re: Warthog config for joystick axis not recognized
Post by: save on February 12, 2016, 01:35:34 AM

What do the device manager think it is ?

Title: Re: Warthog config for joystick axis not recognized
Post by: yipi on February 18, 2016, 07:05:50 AM

Fixed it by deleting the joystick config in the AH setting files. Had to remap everything but at least its working again.
It saw it correctly as combined.