Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: MADe on March 26, 2016, 10:13:14 PM

Title: controller mapping
Post by: MADe on March 26, 2016, 10:13:14 PM

x axis min
         mid
         max

y ditto
z ditto

folks,
under the controller mapping tab, mode 1, scroll down, what does the above options actually do?

can you assign a single axis option, to multiple pots?
ie: a button can over ride an axis, can an axis over ride another axis..........

Title: Re: controller mapping
Post by: Skuzzy on March 27, 2016, 05:59:58 AM

No, those are virtual axises.  The stick is reporting them.

Title: Re: controller mapping
Post by: FLS on March 27, 2016, 09:28:46 AM

Quote from: MADe on March 26, 2016, 10:13:14 PM

x axis min
         mid
         max

y ditto
z ditto

folks,
under the controller mapping tab, mode 1, scroll down, what does the above options actually do?

can you assign a single axis option, to multiple pots?
ie: a button can over ride an axis, can an axis over ride another axis..........

It means that each axis can act as up to 3 button presses instead of an analog axis. For example, if you want a lever to set flaps instead of buttons you could set min to flaps down, mid to nothing, and max to flaps up if you have a spare axis.