Aces High Bulletin Board

General Forums => Open Beta Test => Topic started by: ROCKYDOG on April 18, 2016, 09:34:03 AM

Title: calibration
Post by: ROCKYDOG on April 18, 2016, 09:34:03 AM

clip board not auto changing modes. And my X52 not sowing up on the clip board to calibrate?? But rudder pedals are. Anyone know what to do??

Title: Re: calibration
Post by: Skuzzy on April 18, 2016, 09:38:14 AM

Clip baord does not handle auto-changing modes.  That is done when you change vehicle types (from plane to tank or vice-versa).  When it changes the HOST posts a message to the text buffer notifying you of the change.

If the stick is not in the drop down list in the "Map Controllers" panel, then check to see if Windows is seeing it (via the Control Panel...Joysticks or Gaming Devices, on the System Device Manager...it depends on which version of Windows your computer uses).

Title: Re: calibration
Post by: ROCKYDOG on April 18, 2016, 09:59:03 AM

using windows7

Title: Re: calibration
Post by: ROCKYDOG on April 18, 2016, 10:00:45 AM

winows showing the stick working fine

Title: Re: calibration
Post by: Skuzzy on April 18, 2016, 10:17:36 AM

Does it work in AH2?

Title: Re: calibration
Post by: Randy1 on April 18, 2016, 12:06:47 PM

Last patch the mode did not change when going from plane to tank.  It happened one and only one time.  I did not report it because i could not repeat the problem.  It never happened again which puts into question that what happened, did happen.