Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: AusMedic on January 17, 2017, 12:21:33 AM

Title: Cockpit shaking
Post by: AusMedic on January 17, 2017, 12:21:33 AM

Hi all,
Recently my aircraft have been shaking quite bad when not in auto pilot. I've calibrated my Freedom 2.4 joystick and it continues to happen. My aircraft also want to climb when joystick is in neutral position. Looking at the virtual joystick that also shakes like a mother...

On another note, when I exit the game, since the latest update, I get the error message that Aces High has stopped working.. Anyone else having this issue? Oh and my frame rate has gone from 59 down to 26. I've checked my GPU temp and it is within the correct temperature.

Comp specs:
Windows 10 Pro 64-bit
System Manufacturer: Dell Inc.
System Model: Dell XPS420                 
BIOS: Phoenix ROM BIOS PLUS Version 1.10 A04
Processor: Intel(R) Core(TM)2 Quad  CPU   Q8200  @ 2.33GHz (4 CPUs), ~2.3GHz
Memory: 4096MB RAM
Available OS Memory: 4030MB RAM
         
Card name: AMD Radeon HD 7900 Series
Manufacturer: Advanced Micro Devices, Inc.
Chip type: AMD Radeon Graphics Processor (0x679A)
   
Display Memory: 5068 MB
Dedicated Memory: 3053 MB
Shared Memory: 2014 MB
Current Mode: 1920 x 1080 (32 bit) (60Hz)
Monitor Name: LG FULLHD(Digital)
Monitor Model: LG FULL HD

Cheers
         

Title: Re: Cockpit shaking
Post by: Ramesis on January 17, 2017, 12:07:00 PM

U sure ur not in pre stall... the tendacy to climb may indicate a stall

Title: Re: Cockpit shaking
Post by: AusMedic on January 18, 2017, 12:46:53 AM

No I am in level flight

Title: Re: Cockpit shaking
Post by: 100Coogn on January 18, 2017, 12:57:27 AM

It sounds like you have a bad case of stick-spiking going on.
Try going into Advanced Calibration Settings and check each axis for unusual behavior.

Coogan

Title: Re: Cockpit shaking
Post by: AusMedic on January 19, 2017, 12:41:21 AM

Thanks coogn will do

Title: Re: Cockpit shaking
Post by: DubiousKB on January 19, 2017, 10:31:41 AM

Looking at the "scaled input" vs the "raw input" in the advanced joystick page helps alot... if the raw input is all over the place... that's a bad joystick/axis.    You can compensate to some extent with dead band and scaling... There is a point of no return where if the raw inputs are just ALL over the place, you won't be able to "stabilize" the inputs...

Time for a new joystick, I'm on my second Logitech 3D extreme pro in 2 years.