Aces High Bulletin Board
Help and Support Forums => All things VR => Topic started by: Heater on February 04, 2017, 08:19:14 AM
-
All just bought a Vive and AH looks great, However, I cannot get the warthog to work with the flight controls for the axis.... all other key maps and the throttle are fine.
it looks like it's defaulting to use the Vive controllers but can not find where to turn it off :(
-
It will default to using the Vive controllers, but the Warthog should still be selectable in the Options->Controls->Map Controllers panel (at the top). Does it not show up in the list? If not, that usually means Windows is not properly detecting it.
Then again, I could be full of it as the VR stuff is not something I have a lot of experience with.
-
Have you tried moving your controller to different USB ports? I had to move mine a couple of times until i found a layout that didn't cause contention.
-
All just bought a Vive and AH looks great, However, I cannot get the warthog to work with the flight controls for the axis.... all other key maps and the throttle are fine.
it looks like it's defaulting to use the Vive controllers but can not find where to turn it off :(
Can't you set the Vive controllers to "none" in Options->Controls->Map Controllers and only map pitch and roll to the Warthog?
-
Holy crap heater is alive?
-
Thanks all got it sorted....
all I can is the PUTZ can write some nice code once and awhile....
-
can write some nice code once and awhile....
Who are you , and what have you done with heater?
HiTech
-
Hiya PUTZ...
Looking good I must say!