Aces High Bulletin Board
Help and Support Forums => Help and Training => Topic started by: CAP1 on July 22, 2018, 12:37:30 PM
-
I go into the offline arena, calibrate my stuff, then map out my joystick/throttle buttons/hatswitches using the clipboard. I save the mapping, then launch. when I go to launch, the calibration's gone. I recalibrate, then that's all good.....but my mapping's all gone. if I go ahead and re-map, then the calibration's gone again.
i'm still using ch throttle/combat stick/rudder pedals. the new machine is running windoze10 64 bit, with asus hardware.
-
Something to do with control modes at the top of the control settings screen i assume. Make sure you are mapping for the right mode. I think there is different modes for flight, gvs, gunners ect..
-
Might be a box to click to auto select modes too.. or you can set key commands to select modes manually. Not by the PC to look right now.
-
Are you using the CH software? That could be it, if you are. The Saitek I use was like that. Had an issue with Windows. The Generic Windows drivers work just fine with Saitek. I had buttons that wouldnt work because of the Saitec key/button assigning was canceling my ingame settings. Or may need to go other route if its not a conflict like that, and go through their Target/mapping program and use it for AcesHigh profile. But as mentioned All 4 modes have their own set of default key/button bindings
-
you have to set each control mode now to how you want it. like if you the radio button programed to a certain button then you have to set to same button in all modes--plus in a bomber-you have to set radio for pilot gunner and in bombsight.
also on the bomber-when you go from pilot to bombsight the will cut back you will have to program a wheel or slider to operate throttle from bombsight.