Aces High Bulletin Board
Help and Support Forums => Technical Support => Topic started by: SIK1 on February 24, 2019, 06:14:16 PM
-
I had to do a fresh install of AH yesterday. When I try to map my controllers the button pressed doesn't stay hi-lighted in the menu like it use to do. It also doesn't always change controllers in the menu when I press a button on a different controller. Any help would be appreciated.
:salute
Sik
-
Works as always, for me? However, its a "double tap" to change controller/highlight the button pushed. Unless I misunderstand your problem. I am known to do that a bit :uhoh Had to retire my X52 Hotas on Monday...last week. I had the Warthog Hotas for DCS, but liked the X52 in AH. So I had to map everything again...for me worked as always. One tip I keep hearing...and now use, is saving a copy of my settings folder any time I make changes. Its simple plug n play after a "Full re-install" that way.
-
Hi Sik, just a question as I have no clue, are you doing the remap while using VR or not?
-
Works as always, for me? However, its a "double tap" to change controller/highlight the button pushed. Unless I misunderstand your problem. I am known to do that a bit :uhoh Had to retire my X52 Hotas on Monday...last week. I had the Warthog Hotas for DCS, but liked the X52 in AH. So I had to map everything again...for me worked as always. One tip I keep hearing...and now use, is saving a copy of my settings folder any time I make changes. Its simple plug n play after a "Full re-install" that way.
Same here, I think somewhere along the way it changed from being highlighted to just double-tapping whatever button.
-
Thanks for the reply guys. I wasn't aware that it had changed. I guess I'll have to get in the habit of double tapping when making controller changes.
Hyzer, no this wasn't in vr, but it was the same in vr, I checked.
:salute
Sik