Aces High Bulletin Board
Help and Support Forums => All things VR => Topic started by: Wingnutt on April 17, 2019, 08:36:57 PM
-
In DCS, and Xplane I run the rift at 1.3 and 1.5 pixel density, helps with reading the gauges and the games look better in general.
I don't see an option in AH for it, what is the best way (if any) to adjust it.
-
My bet would be the Oculus tray tool. I used it for a bit, but was too much for my Graphics Card. I adjust it now through NVIDIA Control Panel.
-
I use the OculusDebugTool which is now included with the Oculus software at /Program Files/Oculus/Support/oculus-diagnostics.
-
My bet would be the Oculus tray tool. I used it for a bit, but was too much for my Graphics Card. I adjust it now through NVIDIA Control Panel.
This works PERFECT thanks!
-
My bet would be the Oculus tray tool. I used it for a bit, but was too much for my Graphics Card. I adjust it now through NVIDIA Control Panel.
How did you set that using NVIDIA Control Panel?
-
See the DSR factor setting.
-
How did you set that using NVIDIA Control Panel?
Yeah, misspoke on that one. Must have been thinking of AA,MSAA and all that stuff :uhoh Pixel Density was Occulus Tray Tool. Sorry about that
-
NVidia DSR is the same thing as pixel density override. Just watch your frame rate, there's always a trade off.
-
NVidia DSR is the same thing as pixel density override. Just watch your frame rate, there's always a trade off.
:aok Thanks