Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: anton on February 25, 2002, 12:06:46 AM

Title: number pad/view sticks & holds point of view off center
Post by: anton on February 25, 2002, 12:06:46 AM

sometimes when i use my number pad to look around views it seems to move me around in cockpit & will not stay at home position, I have found a quick fix by hitting alt tab & it will let me reset when i come back in. This alomost always happens at the worst time, I dont always have time to hit alt tab.
 Anton

Title: number pad/view sticks & holds point of view off center
Post by: Lazerus on February 25, 2002, 12:22:54 AM

Try hitting F1 or Home. I have the same problem from time to time, and it is agravating, but have never had to use the alt tab fix.

Title: number pad/view sticks & holds point of view off center
Post by: RangerBob on February 27, 2002, 10:48:55 PM

Also try hitting the escape key, then F1 for the default view. That should reset everything. Escape will bring up the clipboard, but just hit it again to get rid of it.

Ranger Bob

Title: number pad/view sticks & holds point of view off center
Post by: anton on February 27, 2002, 11:52:56 PM

ive tried the home key, it starts me at home position but instantly slides back, also whenver i look around while this is happening each view starts at center he slides as iff i used the arrow keys.
 Anton

Title: number pad/view sticks & holds point of view off center
Post by: SKurj on February 28, 2002, 10:00:10 AM

Check your keymapping....
Make sure numlock is always on...

SKurj

Title: number pad/view sticks & holds point of view off center
Post by: airbull on February 28, 2002, 11:44:32 AM

I have had that happen but using the hat on Saitex joystick. I do the same as u alt tab then back & its ok again.  I just put it down to the wonderfull Saitex software as its not happened using MS stick.