Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Tibbets on February 28, 2002, 05:24:19 PM

Title: x45 help
Post by: Tibbets on February 28, 2002, 05:24:19 PM

Just bought a new x45.....Ive figured out how to program the buttons but havent figured out how to assign the rotary control to trim controls.......I also cant get the mouse on the throttle to work in the game.....thanks for any help
Tibs

Title: x45 help
Post by: 2Late4U on February 28, 2002, 06:43:36 PM

What OS you have?

Oh and stop by here:

http://saitekhelp.simhq.com/

Title: x45 help
Post by: Eagler on March 01, 2002, 06:46:17 AM

why would you want to. Use the mouse as a 4 way hat. Down on mine cycles Gear.

X45 Profile (http://www.pogbird.com/ACESHIGH_X45.zip)

Title: x45 help
Post by: freeze on March 05, 2002, 04:39:56 AM

No way to assign the rotary knobs to the trim buttons. I tried it too and it dosent work right for me. the problem is u cant assign an on /off to an assigned range on the rotary knob. Means when u assigned a range on the knob and u move it in the range it stays on. but to use the trim button right u need a on /off effect. so better waste ur time in my opinion it doesent work.


--------------------
best


Freeze

Title: x45 help
Post by: Eagler on March 05, 2002, 08:18:22 AM

freeze
check out the profile I posted. I have the rotors as trim ( rudder & elevators, aileron is on the throttle rocker)
you have to break the sections into three not two with the center section having no programming at all (dead zone).
 this is just a very small zone right in the middle so you spin back into after making your trim adjustment. Sometimes you have to spin through center to "wakeup" trims.
Not perfect but works well for me and the 109.

gl