Aces High Bulletin Board

General Forums => Films and Screenshots => Topic started by: JoeDirt on March 26, 2002, 05:19:45 PM

Title: hmmm
Post by: JoeDirt on March 26, 2002, 05:19:45 PM

ok....i fast forward to the part i want. then i start select. stop it after 30 secs..... then i do copy se3lect and it plays and everything.....except...no ones there....i hear a cha cha c ha like i get hit a few times, but the lancaster that i shot down is not there. the plane moves exactly how it does when i recorded too.....it even says "you shot down PaNzEr".......but no lancaster.... :( what gives?

Title: hmmm
Post by: Doberman on March 26, 2002, 05:38:28 PM

this is a bug with the 1st version of the film editor.  Have you DL'd the AH patch that was released today?

I haven't had a chance to check it yet, but supposedly this is fixed.

D

Title: hmmm
Post by: Doberman on March 26, 2002, 05:41:27 PM

It works fine now.  DL the patch.

D

Title: clipping films still causes invisible enemy
Post by: Sancho on March 26, 2002, 06:36:11 PM

Hitech, with the new version, I am able to cut a short film clip out of a long one now and the film will play.  But none of the aircraft--even friendlies--appear in the correct position.  I found that they aren't really invisible, just not in the right place, and they move really fast.  It's like they are moving through the entire original film's flight path in the span of the film clip.  Watch this film from Vulgar's POV to see what I mean.

http://www.jump.net/~cs3/tmp/film_clip_broken_enemy.ahf (48k, 25 second film)

Title: hmmm
Post by: Doberman on March 26, 2002, 07:09:23 PM

I take it back.  It seems to work somewhat, but I'm still getting either invisible planes or planes that are very much out of position. :(

D