Aces High Bulletin Board
Help and Support Forums => Technical Support => Topic started by: ccvi on April 07, 2002, 11:15:56 AM
-
I'm using a Logitech StrikeForce 3d. In the stick's setup program "use center forces in forcefeedback games" is disabled, so that I only feel the forces set by AH (no forces at 0 IAS).
It works fine most of the time. BUT only after I have been flying for a few minutes. Before that I don't feel any forces on the roll axis.
Is anything know about this problem?
-
Anyone using a StrikeForce at all?!
-
Have you treid disabling the software for the joy stick and set it up and configure it just in aces high?
-
Removed the autostart of lwemon from the registry, rebootet and tried again. Same problem as before.
I reenabled those forces I had turned off (damage etc.) and crashed a plane. Those forces are there on the roll axis, but no centering force by airspeed/trim force.
-
Problem is still there. I've been running windows 98 / first edition and thought that might have cause the troubles, but now under windows XP the problem is still there.
Elevator axis feedback is correct (near 0 when otr, increasing with airspeed). Works nicely.
Roll axis feedback can be anything. I think it just isn't getting updated too often. On the beginning of the first sortie after startup it's usually zero, when flying for some time set to a somewhat appropriate feedback value in that situation. On later sorties roll axis feedback otr is what it was at the end of the sortie before.
note: i disabled center forces in ff-games, otherwise probably wouldn't feel that something is wrong ;)
-
No ideas what could be wrong?