Aces High Bulletin Board
General Forums => Hardware and Software => Topic started by: 1stnastySQUID on May 06, 2002, 01:00:48 AM
-
I recently purchased a Geforce4 MX 420 and Im getting
very poor results...........
Frame rate on runway --5 FPS
frame rate normal flight at 10k -- 12-15 FPS
Looking straight up at sky -- 45 FPS
This is comparable to my old PCI 32MG Savage4 card.
and is slightly better than my old ATI rage pro turbo 8 MG.(AGP)
system specs:
AMD 750MHZ Athalon w/two cooling fans
AD-11 motherboard
384 MG ram (SDRAM)
win98se O/S
all new drivers for AGPminiport,motherboard,
Vid card and so on............
19" MAG 800v monitor.
7400 rpm seagate HD 8.4 gig
(not even 1 gig used space)
virtual mem set at 250 min and max
I have cable connect (although I dont think thats
the issue)
note:have tried winME to try to resolve
problem (frames were same)
If anyone can help me out with the settings
please do.................
Im sure that I should get more FPS out of this puppy.
Thanks in advance
SQUID :confused:
-
I'd try throughly removing the drivers for the card and reinstalling them. I'm guessing there is a problem here. You *should* get better framerates than that.
Also make sure there isn't an interrupt conflict between the video card and something else.
-
check the bios seting !
-
Get at least the 440MX, some of the 420MX cards use SDR ram and aren't much faster than a GF2MX, also make sure anti aliasing is turned off if you decide to keep it.
I'm very happy with my 440MX.
-
I would never buy MX anything.
For a few bucks more you get the real thing.
-
When I first got my GeForce 2 GTS 64mb sometime ago I had a similar problem. It turned out to be the 4 in 1 VIA drivers not working properly - the 4 x AGP wasn't even working. Try installing the latest 4 in 1 VIA drivers and then experiment with using some of the latest Detonator Drivers.
Good luck!