Aces High Bulletin Board
General Forums => Aces High General Discussion => Topic started by: onyer6 on June 29, 2002, 12:51:18 AM
-
Win98se. Used the supplied drivers. Most things work, but I do believe I've lost my ailerons, though they work fine in EAW? Some setting I'm missing? I've removed my MS S pre pro. When I call up the js in control panel and hit properties I get an error message about no supported software? I've calibrated within AH.
-
Do you have the version 3 drivers?
If not, get them.
And go into AH, go into setup, joystick, and set all the inputs again.
-
Hi!
Check out Ron Hunts very good unoffical Saitek Hepl Pages (http://saitekhelp.simhq.com/SGE%20Start.htm) .
From there you can get SGE version 3.0 plus find tons of good information how to this and that with X45.
:)
Edit typo
-
thank guys.
p.s. my ailerons and elevators seem to be linked (rear view aces high).
-
After a second reinstall they weren't working until after I calibrated. Though I checked out Ron Hunt's excellent page, the current install goes better than the older one he described. We'll see how this plays out. I think I had ailerons on my original install and somehow lost them after programming some buttons. Thanks y'all. See ya inda skies....
-
Well, it's my experience that you don't need no stinkin alerions. Somebody will just shoot them off anyway.:D
Of course, this could be from My COMPLETE & TOTAL LACK OF ABILITY as a sim pilot.
No really I have an x-45 but I don't know how to help you out.
Sorry
JimC
-
LOL! My first time back at AH with the new stick I found I needed neither ailerons, flaps, engine, prop or tail. I found the windscreen invaluable though, for keeping the burning debris outta yer face so's yuh can watchyerself auger in w/o any visual obstuctions.....