Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: GA on July 03, 2002, 07:04:15 PM

Title: Cant get green txt on bombing when finish calibrating!!!!
Post by: GA on July 03, 2002, 07:04:15 PM
I set all things correct and get all to yellow!
But when I shall exit calibration, I get the txt to red again?

And if I get it to green ?, when do you know when to drop your bombs?
Title: Cant get green txt on bombing when finish calibrating!!!!
Post by: Tracer-15 on July 03, 2002, 09:02:46 PM
what i found is that.......when you go into calibration mode.....follow the steps from the top down.......pick a point and follow it with the +......and hold the Y (for ex......its default key) for 2 secs....to set speed.........then go to clipboard and click on the target you want to bomb.....in its general area......to set alt of target........then open bomb bays......wait a second......then hit they key to exit claibration..........if it works you will go green
Title: Cant get green txt on bombing when finish calibrating!!!!
Post by: snafu on July 04, 2002, 07:12:02 AM
Hi GA,
 Had exactly the same problem on my 1st couple of runs and was ready to give it up as a bad job. I think the reason is you have to keep the crosshairs perfectly stationary on the target while pressing the "y" (Default) key. Make sure you are zoomed in to a maximum (Using "[" & "]") that appears to have been my problem at least. ( I think if you are not zoomed in fully any movement is exagerated (sp)? and that stops the calibration completing). I use Kwassa's tutorial and it works fine now. (Although I do find I get more accurate results if I open the doors before anything else).

Hope this helps

TTFN
snafu
Title: Cant get green txt on bombing when finish calibrating!!!!
Post by: GA on July 04, 2002, 07:21:06 AM
PUNT Snafu;), just what was my problem;). Just keep the Zoom in max, and held it real steady 2-3 seconds:D