Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: JJ on July 09, 2002, 06:12:31 PM

Title: Bomber Sights
Post by: JJ on July 09, 2002, 06:12:31 PM

After Calerbration I go To Bomb Sight Screen Travels Left to Right Not Top to Bottom WHATS wrong Any ONE HELP PLZ????????????JPJ

Title: Re: Bomber Sights
Post by: Flossy on July 09, 2002, 07:07:07 PM

Quote

Originally posted by JJ
After Calerbration I go To Bomb Sight Screen Travels Left to Right Not Top to Bottom WHATS wrong Any ONE HELP PLZ????????????JPJ

Where abouts are you marking your point?  For best results, mark directly below the aircraft, which will give a better indication of your direction of travel and altitude - marking at a distance may be misleading...

Title: Bomber Sights
Post by: JJ on July 09, 2002, 09:28:39 PM

Thks Flossey I calerbrat Fine Its After I have Calber And go Back to Bomb Sight My trerain Dose not Travel Rhight When I look Down to Drop Bombs Ground is Traveling From RHight to Left Not
Top screen to Bottom any One Any HELP PLZ JPJ:confused:
:confused:

Title: Bomber Sights
Post by: airbull on July 10, 2002, 10:33:31 AM

Did u press the key to come out of calibration mode.
If you can still move the cross about U didn t.
If u did, go out of bombsight then back in & retry calibration & see if its ok then.

Title: Bomber Sights
Post by: SKurj on July 10, 2002, 01:00:25 PM

try calibrating again, and being sure to hold steady during the 'mark' process.

I've had this happen to me before as well, and usually going back in and recalibrating fixes it.  


SKurj