Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: Chaos68 on September 30, 2002, 03:47:59 PM

Title: joystick problem?
Post by: Chaos68 on September 30, 2002, 03:47:59 PM

Im looking on something to help me set up my joystick with the PITCH and ROLL in the AH setup?


I have a Microsoft forcefeedback2 and it seems like i cant pull up fast enough.

I tryed it out in the 109-g10 and the La7 and in both planes i couldnt pull up fast enough.
I know speed has alot to do with it but i tryed at 100mph and 200mph in both planes and i had almost the same problem.

For example i was in a turn fight in my 109 and i was fighting a p51 and i just couldnt snap and roll or bank to get him then finally i ended up being a lawn dart at 200mph because i couldnt pull up in time. :(

can anyone help?

Title: joystick problem?
Post by: Ghosth on September 30, 2002, 10:39:48 PM

Have you tried it with the FF turned off? Do you get the same effect?

Where are the damper & sliders set at for pitch?

There are a LOT of variables.

Title: joystick problem?
Post by: Chaos68 on October 01, 2002, 07:35:10 PM

my levels are set the same. (on the low end).

I was woundering what i should set my levels to? the ones that go from 10 to 90.

Title: joystick problem?
Post by: Knox on October 02, 2002, 06:38:14 AM

Turbot told me that if u set all ur sliders to  the top and but ur dead bands and damping down to the bottem, it works great and i can actually turn fight now, this setting allows u complete control and manueverability of ur aircraft :)

Knox

Title: joystick problem?
Post by: blackfalcon4 on October 02, 2002, 07:50:17 AM

YOYO,

  Make sure the stall-limiter option isn't enabled.

 Its in setup on the clipboard

Title: joystick problem?
Post by: Uncle on October 03, 2002, 03:05:07 AM

Chaos:
    Look for my thread on page 2 of this section. Someone's posted their settings and it's helped me heaps. Hope it works for you.

Uncle.