Aces High Bulletin Board

General Forums => Aces High General Discussion => Topic started by: Citabria on June 10, 2000, 02:02:00 AM

Title: the horizon is sticky, let go of my plane stupid horizon
Post by: Citabria on June 10, 2000, 02:02:00 AM

I've found it quite odd that the horizon has a certain affect on my airplane but I think its my stick scaling settings or the plane i'm flying

when doing hammerheads a nice steady rotation happens until the horizon then it stops... then continues.

negative g pushovers above the horizon are not to hard but once you hit the horizon the nose stops... then starts going down again.

is this related to the dampener or stick callebration? I noticed w heavy dampening the controls stop at the midpoint and continue... perhaps it is related.

or is it stick forces modelling?

[This message has been edited by Citabria (edited 06-10-2000).]

Title: the horizon is sticky, let go of my plane stupid horizon
Post by: Citabria on June 10, 2000, 02:11:00 AM

ok upon further contemplation I suggest disregarding this thread   (http://bbs.hitechcreations.com/smf/Smileys/default/smile.gif)

checked the spitV excellent -g pushover
must be plane related and thus... supposed to be that way.

[This message has been edited by Citabria (edited 06-10-2000).]

Title: the horizon is sticky, let go of my plane stupid horizon
Post by: hblair on June 10, 2000, 03:04:00 AM

you been drankin?