Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: maxtor on January 06, 2003, 10:09:20 AM

Title: Can't get my brakes to work
Post by: maxtor on January 06, 2003, 10:09:20 AM

I can not get my wheel brakes to work.   Not on keyboard or on stick.  I have mapped and I have remapped both - for example the joystick.  The mapper seems to function correctly (button indicates on mapper control panel when I press it)  However when I go to use the function, no brakes.

All other functions map fine and normal (flaps, guns, etc etc etc.)

I am clueless - any suggestions?

(going to post this in technical support)

Title: Can't get my brakes to work
Post by: San on January 06, 2003, 11:49:13 AM

Check and make sure your throttle is calibrated correctly your brakes might be functioning but your throttle might not be all the way to idle.

Title: Can't get my brakes to work
Post by: snocone on January 08, 2003, 12:01:30 PM

make sure you are holding down the button, the brakes are not a toggle command, you must hold down on them, i mapped them to a switch on my throttle control instead off a button, that way i just turn the switch on and they stay on, hope this helps

Title: Can't get my brakes to work
Post by: bigsky on January 10, 2003, 03:09:07 AM

wheels must be on the ground to work. c and v are the ones i use for right and left wheel brakes or space for both at the same time.