Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Majors on January 08, 2003, 01:00:41 PM

Title: CH pedals, throttle and fighterstick USB
Post by: Majors on January 08, 2003, 01:00:41 PM

Hi Mates

Have just gotten the CH pedals, Pro throttle and Fighterstick USB.

My old set up (same controls) is running through a game port.

I have installed a USB PCI card to run the new controls.

Question, will I have any difficulty running AH after I get this done?

Anyone else done this?

Appreciate any advice.



Majors
249 RAF

Title: CH pedals, throttle and fighterstick USB
Post by: woodfordb on January 08, 2003, 02:19:17 PM

I run the same setup (USB).
You will need to reconfigure AH to use the new devices on the correct axis allocations.

But no, it will or work fine.. and its a joy to use. :)

Mandrill

Title: CH pedals, throttle and fighterstick USB
Post by: Majors on January 08, 2003, 03:10:05 PM

Hi Mate

Thanks for the responce.  Once I get everything hooked up may have to call on you for advice on how to configure in AH.




Majors

Title: CH pedals, throttle and fighterstick USB
Post by: DAVENRINO on January 08, 2003, 04:52:21 PM

Majors,
Check out this thread.  DJ229

http://www.hitechcreations.com/forums/showthread.php?s=&threadid=70564

Title: CH pedals, throttle and fighterstick USB
Post by: Majors on January 08, 2003, 05:42:00 PM

Hi Davenreno

Great attachment.  I am going to print that whole thing out and get these things running.

Many thanks mate.



Majors

Title: CH pedals, throttle and fighterstick USB
Post by: DAVENRINO on January 08, 2003, 06:26:04 PM

NP but credit belongs to Airspro for his great posts.
DJ229