« previous next »
Pages: [1]   Go Down

Author Topic: Small Problem in the Dora  (Read 351 times)

Offline Hopper

  • Silver Member
  • ****
  • Posts: 1421
Small Problem in the Dora
« on: June 11, 2009, 11:38:59 PM »
I've noticed when I lower the RPM's at certain times they will not go below 2500.  I think this is just a visual glitches because I can tell by the EA6B that it goes lower than that.  I will look down some time later and it will have dropped below 2500 to its correct position.  I have only seen this happen in the 190-D.  Not a big problem, but maybe someone could pull out the iron and take out some wrinkles sometime.

Edit: Should have went to Bug Reports, my bad.
« Last Edit: June 11, 2009, 11:45:15 PM by Hopper »
Logged
Hopper


JG/11

Offline CountD90

  • Nickel Member
  • ***
  • Posts: 375
Re: Small Problem in the Dora
« Reply #1 on: June 12, 2009, 02:44:28 AM »
at high speeds the rpm wont go below a certain point IIRC
Logged
GameID:Count
The Misfit Toys
Quote from: Wreked
If you are feeling a little useless, offended, or depressed, just remember that you were once the fastest and most victorious little sperm out of millions.

Offline Hopper

  • Silver Member
  • ****
  • Posts: 1421
Re: Small Problem in the Dora
« Reply #2 on: June 12, 2009, 05:55:48 PM »
I'll test it again your probably right.
Logged
Hopper


JG/11
Pages: [1]   Go Up
« previous next »