Didn't see this posted earlier. Saitek has released an offical version of its programming software for XP
link A couple of suggestions:
1. If your using an Microsoft Intelli-mouse, after installing the Saitek software goto the systems folder and disable Saitek Magic Mouse (instructions are located at the above link). If you don't your mouse will not work properly and will require a reboot everytime your activate the profiler.
2. If your using bands on the rotories and the rocker switch for the rudder, make sure you include a dead band in your programming of these.
I'm still having problems with mouse buttons on the throttle. I use them for auto pilot and haven't been able to get them to set properly. If I figure this out I'll post it. Meanwhile any advice would be appreciated.
WxMan (WeatherMan)
