Author Topic: Spit Mark IX Stall & Spin Recovery  (Read 493 times)

Offline waystin2

  • Plutonium Member
  • *******
  • Posts: 10166
Spit Mark IX Stall & Spin Recovery
« on: September 07, 2007, 06:59:48 AM »
I asked about the stall limiter last week, and by popular recommendation have been flying without.  So it's on to the next issue.  I have been pushing my AC to the limit and beyond, and occasionally that leads to stalls and spins.  Any suggestions on recovering from stalls & spins in the Mark IX?  Thank you in advance for the schooling!
CO for the Pigs On The Wing
& The nicest guy in Aces High!

Offline WMLute

  • Platinum Member
  • ******
  • Posts: 4512
Spit Mark IX Stall & Spin Recovery
« Reply #1 on: September 07, 2007, 07:20:32 AM »
"Never tell people how to do things. Tell them what to do and they will surprise you with their ingenuity."
— George Patton

Absurdum est ut alios regat, qui seipsum regere nescit

Offline Scca

  • Gold Member
  • *****
  • Posts: 2718
Spit Mark IX Stall & Spin Recovery
« Reply #2 on: September 07, 2007, 07:31:47 AM »
Quote
Originally posted by WMLute
Stall Recovery
Good advise, but I fly the IX a lot and find if you do a nose up stall, and get into a flat spin, you are in big trouble.  I have never been able to get out of that.
Flying as AkMeathd - CO Arabian Knights
Working on my bbs cred one post at a time

http://www.arabian-knights.org

Offline reeb

  • Copper Member
  • **
  • Posts: 292
Spit Mark IX Stall & Spin Recovery
« Reply #3 on: September 07, 2007, 08:45:06 AM »
Spit 9 is an ubercraft.....I flew this plane as my main ride for over a year. When you do a nose up stall use rudder and flaps. It is one of the most forgiving planes and it is easily recovered from spins you just gotta be gentle on the stick. If you yank to hard in a direction without your stick set right its gonna spin. I had a friend i tryed getting into AH and he played in the H2H and he always had problems with any craft spinning on him cuz he would yank way to hard in a direction. Some times you gotta treat your plane like a lady and use a gentle touch.

Offline Latrobe

  • Persona Non Grata
  • Platinum Member
  • ******
  • Posts: 5975
Spit Mark IX Stall & Spin Recovery
« Reply #4 on: September 07, 2007, 10:45:16 AM »
In a nose up stall push ailerons, elevators, and rudder all one way for a few seconds (2-3 sec should be good) then everything the other way. It works for the 16 but im not sure about the 9. I'll have to test it out.

Offline Optiker

  • Zinc Member
  • *
  • Posts: 81
Spit Mark IX Stall & Spin Recovery
« Reply #5 on: September 07, 2007, 12:02:49 PM »
Nose up spins are a bear - I've found that in some aircraft (Spit V, VIII) that the only way to get the nose down is drop landing gear.
Regards,
Optiker

Offline Scca

  • Gold Member
  • *****
  • Posts: 2718
Spit Mark IX Stall & Spin Recovery
« Reply #6 on: September 07, 2007, 01:51:18 PM »
Quote
Originally posted by Optiker
Nose up spins are a bear - I've found that in some aircraft (Spit V, VIII) that the only way to get the nose down is drop landing gear.
Regards,
Optiker
Ahhhh  haven't tried that...  
Thanks
Flying as AkMeathd - CO Arabian Knights
Working on my bbs cred one post at a time

http://www.arabian-knights.org

Offline SlapShot

  • Plutonium Member
  • *******
  • Posts: 9121
Spit Mark IX Stall & Spin Recovery
« Reply #7 on: September 08, 2007, 09:01:15 AM »
Try dropping your gear too ...
SlapShot - Blue Knights

Guppy: "The only risk we take is the fight, and since no one really dies, the reward is the fight."

Offline waystin2

  • Plutonium Member
  • *******
  • Posts: 10166
Spit Mark IX Stall & Spin Recovery
« Reply #8 on: September 08, 2007, 09:47:30 AM »
I tried the gear idea, it just ripped them apart.  I chopped throttle using gentle movements of rudder & such, and it seems hit or miss.  I flew the Mark 8 stalled three times and pulled out 2 of the 3.  The Mark 8 seems to have an easier recovery.
CO for the Pigs On The Wing
& The nicest guy in Aces High!

Offline SgtPappy

  • Silver Member
  • ****
  • Posts: 1174
Spit Mark IX Stall & Spin Recovery
« Reply #9 on: September 08, 2007, 11:55:24 PM »
Theoretically, you could try to firewall the throttle if you're not doing so already. Then follow make all the control surfaces follow in the direction of torque, i.e. left.

In a spitfire I, you're screwed.
I am a Spitdweeb

"Oh I have slipped the surly bonds of earth... Put out my hand and touched the face of God." -J.G. Magee Jr.