It Won't Work...

[Brethon]

For somereason AH stopped working, so I un-installed it, and D/Led the .45 base.  But no matter what setup I use I get dumped.  I've tried everything from 640x480 16bit to whatever the highest is, and then all with 32bit....can somebody help me?

------------------
"Do unto others....and get your head blown off." -Brethon

[This message has been edited by Brethon (edited 01-07-2000).]

[Rude]

Without knowing what your sys is, I would reccomend the following....

Delete all AH content..chk registry as well...then try reinstall.

If you made vid card upgrade delete all old hardware settings from registry as well.

Good Luck
Rude

[Peter V]

I have the same problem.  I've downloaded it several times now and when I try and set my resolution I get the following error, no matter what.

ACESHIGH caused an invalid page fault in
module ACESHIGH.EXE at 015f:0041c720.
Registers:
EAX=00000000 CS=015f EIP=0041c720 EFLGS=00010246
EBX=00cc0000 SS=0167 ESP=00dcfb7c EBP=00dcfe38
ECX=00000000 DS=0167 ESI=005927a8 FS=49df
EDX=00000000 ES=0167 EDI=00000000 GS=0000
Bytes at CS:EIP:
8b 41 10 c3 90 90 90 90 90 90 90 90 90 90 90 90
Stack dump:
004205bf 00000000 00000000 00cc0000 00000000 0041ea8c 0046581a 00000000 0045cdff 0045bb82 00428fa3 00429ef4 00000000 5b7a7978 5f5e5d5c 63626160


I have a voodoo3 2000 PCI, so it should be fairly up to date.  Any suggestions?

Thank you.

Warmest Regards,

Peter VanderZwet

[Pyro]

Go into your setting folder and delete your video.cfg file.  Restart AH and when it asks for your video options, put in all the minimum settings and see if you can run it.  



------------------
Doug "Pyro" Balmos
HiTech Creations

"The side with the fanciest uniforms loses."