« previous next »
Pages: [1]   Go Down

Author Topic: crap :(  (Read 436 times)

bike killa

  • Guest
crap :(
« on: June 30, 2000, 03:07:00 AM »
here i go again
my config is:
A-Bit BH6
Celeron 366A
Savage3DBlaster4
SB128PCI
64Mb RAM
yesterday i was trying to set my bus speed to 78, 81, 75, or even 100Mhz, but it was auttomaticly switched to 66Mhz again or i swa message like CPU is unworkable, unstable or something like that...i was enable do do it before but now it didn't working   someone have any idea what's going on? as i said i did it before and i was enable to load Winblows (hehe Windows worked only in 1st reboot   but now i'm really surprised...maybe i missed something?
Logged

Offline Gunthr

  • Gold Member
  • *****
  • Posts: 3043
      • http://www.dot.squat
crap :(
« Reply #1 on: June 30, 2000, 05:28:00 AM »
Sounds like the problem is the SPEED ERROR HOLD setting.

This option appears when you make overclocking changes in set-up.

It is "enabled" by default. Just disable it, and you should be good to go.
Logged
"When I speak I put on a mask. When I act, I am forced to take it off."  - Helvetius 18th Century

Meisseli

  • Guest
crap :(
« Reply #2 on: June 30, 2000, 05:29:00 AM »
There's "Speed Error Hold" (or something like that) option in CPU SOFT MENU. Choose Disabled, then you can choose other FSB speeds that was processor is meant for.
Hope this helps...

<Meisseli>
Logged

Offline blitz

  • Silver Member
  • ****
  • Posts: 1007
crap :(
« Reply #3 on: June 30, 2000, 06:55:00 AM »
Hi bike killa,

Celerons are supposed to run at 66MHz , i am surprised that it worked before.
Celi 400 oc to 450 MHZ here.

blitz
Logged
Pages: [1]   Go Up
« previous next »